Draytek Vigor 2110 User Manual page 101

PPP Setup
IP Address Assignment
Method(IPCP)
WAN IP Network
Settings
After finishing all the settings here, please click OK to activate them.
Vigor2110 Series User's Guide
TTL value is set by telnet command.
Default – Click this button to reset to factory setting.
If you choose WiMAX, you are allowed to go to WiMAX
Backup setup page to configure detailed settings.
PPP Authentication – Select PAP only or PAP or CHAP
for PPP. If you want to connect to Internet all the time, you
can check Always On.
Idle Timeout – Set the timeout for breaking down the
Internet after passing through the time without any action.
Fixed IP - Usually ISP dynamically assigns IP address to
you each time you connect to it and request. In some case,
your ISP provides service to always assign you the same IP
address whenever you request. In this case, you can fill in
this IP address in the Fixed IP field. Please contact your ISP
before you want to use this function. Click Yes to use this
function and type in a fixed IP address in the box.
Fixed IP Address -Type a fixed IP address.
Obtain an IP address automatically – Click this button to
obtain the IP address automatically.
Specify an IP address – Click this radio button to specify
some data.
IP Address – Type the IP address.
Subnet Mask – Type the subnet mask.
93