Draytek Vigor 2110 User Manual page 93

PPP/MP Setup
IP Address Assignment
Method (IPCP)
Vigor2110 Series User's Guide
APN Name – APN (Access Point Name) is provided by
your ISP for identifying different access points. Simply
click Apply to apply such name. Finally, you have to click
OK to save the setting.
Apply – Activate the function of identification.
Modem Dial String - Such value is used to dial through
USB mode. Please use the default value. If you have any
question, please contact to your ISP.
PPP Username - Type the PPP username (optional).
PPP Password - Type the PPP password (optional).
PPP Authentication – Select PAP only or PAP or CHAP
for PPP.
Index (1-15) in Schedule Setup - You can type in four sets
of time schedule for your request. All the schedules can be
set previously in Application >> Schedule web page and
you can use the number that you have set in that web page.
WAN Connection Detection - Such function allows you to
verify whether network connection is alive or not through
ARP Detect or Ping Detect.
Mode – Choose ARP Detect or Ping Detect for the system
to execute for WAN detection.
Ping IP – If you choose Ping Detect as detection mode, you
have to type IP address in this field for pinging.
TTL (Time to Live) – Displays value for your reference.
TTL value is set by telnet command.
Default – Click this button to reset to factory setting.
If you choose WiMAX, you are allowed to go to WiMAX
Backup setup page to configure detailed settings.
PPP Authentication – Select PAP only or PAP or CHAP
for PPP. If you want to connect to Internet all the time, you
can check Always On.
Idle Timeout – Set the timeout for breaking down the
Internet after passing through the time without any action.
Usually ISP dynamically assigns IP address to you each
time you connect to it and request. In some case, your ISP
provides service to always assign you the same IP address
whenever you request. In this case, you can fill in this IP
address in the Fixed IP field. Please contact your ISP before
you want to use this function.
WAN IP Alias - If you have multiple public IP addresses
and would like to utilize them on the WAN interface, please
use WAN IP Alias. You can set up to 8 public IP addresses
other than the current one you are using. Notice that this
85