Arriflex 435 - CEI Color Six Operator's Manual

Arriflex 435

Install the CEI/435 optics as follows:
1. Check that the camera locator screw and positionable C-
mount lock screw are reasonably tight. For Super 35 models,
thread the reducing optic into the rear of the tap lens. Do not
use the blue spacer ring.
2. Screw the tap lens (C-mount threads) into the Color Six
tightly, but do not overtighten.
3. Loosen the positionable C-mount lock using a 3/32-inch hex
driver.
4. Loosen the 3/32 hex screws in the headpiece dovetail
adjustment on the Color Six .
5. Rotate the entire tap lens clockwise until the 435 locating
hole lines up directly forward in line with the body of the
video camera. Some friction is normal.
6. Tighten the positionable C-mount lock.
7. Loosen the camera locator lock screw using the 3/32-inch
hex driver.
8. Rotate the camera locator ring until the camera locator screw
aligns with the #8-32 threaded hole on the face of the Color
Six .
9. Using a ball-tip 3/32 hex driver, insert and tighten the camera
locator screw.
10. Tighten the camera locator lock screw.
Next mount the Color Six to the 435:
31