Saving Custom Settings; Power Switch; Lcd Monitor - CEI Color Six Operator's Manual

14

Saving Custom Settings

All of the manual settings are automatically stored in non-
volatile RAM for future use, even if camera power is turned
off or disconnected, so you can switch between MANUAL
and AUTO modes without losing them. Should your shoot-
ing conditions change radically, you can reset them all at the
next to the last menu, SET ALL TO DEFAULT, and start
over.
Operation

Power Switch

The power switch is located on the back panel (see figure 3).
A green LED above the switch will illuminate two or three
seconds after the switch is set to ON, indicating that the
internal power supplies have stabilized. The LED will blink
on and off if the input power drops below 10 volts.
If the LED fails to illuminate, check the input voltage and
polarity (see Power, page 5).

LCD Monitor

When turned on, the built-in LCD monitor displays the "B"
video signal. The backlight has two brightness settings,
selectable by the LCD OFF/ON/HIGH switch. Brightness,
contrast, color depth and tint of this display are
electronically adjustable using the multipurpose control (see
page 12).