Installing The Ap; Using The Ceiling Rail Adapter - Aruba AP-130 Series Installation Manual

Installing the AP

Service to all Aruba Networks products should be performed by trained service personnel only.

Using the Ceiling Rail Adapter

The AP130 series ships with two ceiling rail adapters for 9/16" and 15/16" ceiling rails.
Make sure the AP fits securely on the ceiling tile rail when hanging the device from the ceiling, because poor
installation could cause it to fall onto people or equipment.
1. Pull the necessary cables through a prepared hole in the ceiling tile near where the AP will be placed.
2. Place the adapter against the back of the AP with the adapter at an angle of approximately 30 degrees to
the tabs (see
3. Twist the adapter clockwise until it snaps into place in the tabs (see
Figure 3 Attaching the Ceiling Rail Adapter
4. If necessary, connect the console cable to the console port on the back of the AP.
5. Hold the AP next to the ceiling tile rail with the ceiling tile rail mounting slots at approximately a 30-
degree angle to the ceiling tile rail (see
6. Pushing toward the ceiling tile, rotate the AP clockwise until the device clicks into place on the ceiling
tile rail.
Aruba AP-130 Series Access Point
Figure 3).
| Installation Guide
Figure 4). Make sure that any cable slack is above the ceiling tile.
Figure 3).
7