Raymarine SPX 10 Installation Manual page 18

10
Powering SeaTalk
The SPX SmartPilot normally provides power to the SeaTalk
decide to power the SeaTalk
SeaTalk ng system with separate power supply
In installations where the SeaTalk
running an NMEA 2000-compliant system, the SeaTalk
terminal on the SPX SmartPilot must be moved to the OFF position
.
POWER
OFF
FAULT
ng
SeaTalk
backbone cable
ng
ng
system separately.
SMARTPILOT
ST70 controller
ON
FAULT
ng
backbone is powered separately, or, if you are
SmartPilot
computer
ST70 instrument
12 V Power Supply
(via breaker/fuse)
ng
system but you may
ng
switch above the SeaTalk
Course computer
power supply
(via breaker/fuse)
ST70 instrument
ng
SeaTalk bus
Power cable
ng
D10465-1