Operating Safety - WACKER Group PDT 2 Repair Manual

Safety Information
1.1

Operating Safety

DANGER
1.1.1
1.1.2
1.1.3
1.1.4
1.1.5
1.1.6
1.1.7
1.1.8
1.1.9
1.1.10 ALWAYS store the equipment properly when it is not being used.
wc_si000176gb.fm
Internal combustion engines present special hazards during operation
and fueling. Read and follow the warning instructions in the engine
owner's manual and the safety guidelines below. Failure to follow the
warnings and safety guidelines could result in severe injury or death.
NEVER allow anyone to operate this equipment without proper
training. People operating this equipment must be familiar with the
risks and hazards associated with it.
NEVER touch the engine or muffler while the engine is on or
immediately after it has been turned off. These areas get hot and may
cause burns.
NEVER use accessories or attachments that are not recommended by
Wacker. Damage to equipment and injury to the user may result.
NEVER pump volatile, flammable or low flash point fluids. These fluids
could ignite or explode.
NEVER pump corrosive chemicals or water containing toxic
substances. These
environmental hazards. Contact local authorities for assistance.
ALWAYS read, understand, and follow procedures in the Operator's
Manual before attempting to operate the equipment.
ALWAYS be sure operator is familiar with proper safety precautions
and operation techniques before using machine.
ALWAYS be sure the machine is on a firm, level surface and will not
tip, roll, slide, or fall while operating.
ALWAYS close fuel valve on engines equipped with one when
machine is not being operated.
Equipment should be stored in a clean, dry location out of the reach of
children.
fluids could create
4
PD 2/3
serious health and