Maintenance And Inspection - Hitachi D10VH Safety Instructions And Instruction Manual

Table of Contents

Advertisement

Available languages

Available languages

English

MAINTENANCE AND INSPECTION

WARNING:
1. Inspecting the drill bits
Since use of a dull tool will cause motor malfunctioning and degraded efficiency, replace
the drill bit with a new one or resharpening without delay when abrasion is noted.
2. Inspecting the screws
Regularly inspect all screws and ensure that they are fully tightened. Should any of the
screws be loosened, retighten them immediately.
WARNING:
3. Keeping after use
When not in use, the Power tool should be kept in a dry place out of the reach of
children.
4. Inspecting the carbon brushes
For your continued safety and electrical shock protection, carbon brush inspection and
replacement on this tool should ONLY be performed by a HITACHI AUTHORIZED
SERVICE CENTER.
5. Maintenance of the motor
The motor unit winding is the very "heart"' of the power tool. Exercise due care to
ensure the winding does not become damaged and/or wet with oil or water.
6. Service and repairs
All quality power tools will eventually require servicing or replacement of parts because
of wear from normal use. To assure that only authorized replacement parts will be
used, all service and repairs must be performed by a HITACHI AUTHORIZED SERVICE
CENTER, ONLY.
7. Service parts list
CAUTION:
Repair, modification and inspection of Hitachi Power Tools must be carried out by an
Hitachi Authorized Service Center.
This Parts List will be helpful if presented with the tool to the Hitachi Authorized
Service Center when requesting repair or other maintenance. In the operation and
maintenance of power tools, the safety regulations and standards prescribed in each
country must be observed.
MODIFICATIONS:
Hitachi Power Tools are constantly being improved and modified to incorporate the latest
technological advancements.
Accordingly, some parts (i.e. code numbers and/or design) may be changed without prior
notice.
14
Be sure to switch power OFF and disconnect the plug from the
receptacle during maintenance and inspection.
Using this drill with loosened screws is extremely dangerous.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents