Hitachi D10VH Safety Instructions And Instruction Manual page 12

English
10. Attaching
accessory)
For hook (side-attaching) (Fig. 7)
Fix the hook firmly on the desired side of
the gear cover using M10 bolt which is
supplied with hook.
For hook (A) (top-attaching) (Fig. 8)
To attach the hook (A), it is necessary to
disassemble the handle portion which
covered the tool's electrical system. For your
continued safety and electrical shock
protection, installing the hook (A) on this
drill should ONLY be performed by a
HITACHI AUTHORIZED SERVICE CENTER.
CAUTION:
When the power tool is used with a hook
fixed to it, pay attention to the following
points:
Before hanging the main unit from the waist
belt, make sure that the drill has come to a
complete stop.
While it is suspended from the waist belt,
the power plug must be disconnected from
the power source.
Do not walk about with the power tool
hanging from the waist belot.
In the case of operation in a high place, it is
dangerous to drop the tool accidentally. If
the hook is deformed or hung from the
wrong position, there is danger that the
hook will slip off and the tool will fall.
Be careful to avoid danger.
In making a through hole, the power tool
sometimes shakes violently when the
workpiece is pierced, from example. Be
careful you are not hurt by the hook even if
such situation happens.
12
the hook. (Optional
Loosen Tighten
Fig. 6
M10 Bolt
Hook
Fig. 7
Fig. 8
Side handle
Hook (A)