Advertisement
14
Image after removal of control arm
girdle.
Remove OEM spring and bumpstop
15
Accurately cut top of bump stop so final
length below dashed line is: 3 1/8 "
16
Install front lowering spring and
modified bumpstop
17
NOTE: Rotate lower rubber spring
mount so spring registers properly on
both upper and lower rubber mounts
18
Re-install control arm girdle.
NOTE: DO NOT grab damper shaft with
any tools while tightening the nylock
nut.
Reinstall using same tool as was used
during removal
8 of 28
Advertisement
