Advertisement
3
Slide support bar out from rubber hangers
on both sides.
NOTE: Spraying lubricant inside rubber
hanger eases removal
4
With all fasteners and clamps
removed/loosened, remove entire exhaust
system as a whole
5
Ready for the installation of new STaSIS
Performance exhaust system
STaSIS Performance exhaust shown:
6
Start with installing the mid pipe to catalytic
convertors, and support bars into
corresponding hangers
7
Now install passenger's side rear section
to mid pipe, followed by driver's side.
Make sure to install support bars into
corresponding hangers
NOTE: Leave clamps loose enough to
allow for adjustment
25 of 28
Advertisement
