Moving Extensions - Nortel M7310 Quick Programming Manual

Moving Extensions

This feature allows you to move an extension to another socket without losing all of its
custom programming or its assigned extension number.
There are some things to know about this feature to ensure success:
• It may take up to 60 seconds for the Central Control Unit to recognise the extension
at the new location.
• Direct Inward Access (DIA) lines are virtual lines, not physical ones. Therefore,
when you move an extension, the DIA lines programmed for that extension are not
moved with the telephone.
• Make one complete move at a time. In other words, take one extension, plug it in to
the new socket and wait for the CCU to accept it before using the abandoned socket.
• If you do not wait, the new extension going into the old socket receives all the
programming from the old extension.
• It is important to ensure that all sockets used support a Norstar unit.
• If a fax machine, ATA, analogue telephone or modem was plugged into the socket,
do not use a Norstar unit in that socket.
ACTION
1. Begin the session by following the instructions under "To begin
a programming session" on page 9, and by using the System
Administrator Plus password.
2. Press ' six times.
3. Press ≠.
4. Press ' .
5. Press ≠.
6. Press ' until this appears on the display:
7. Press to choose Y (Yes).
CHANGE
8. Press ® to exit the session.
9. After a few seconds, the date and time reappear on the display.
32
VISUAL DISPLAY
Terminals&Extns
System prgrming
Hunt Groups
Featr settings
Backgrnd music:N
CHANGE
Extn relocatn:N
CHANGE
Extn relocatn:Y
CHANGE
End of session
1 Jan 1:00 am