Operation And Tilling Tips; Check Oil And Gas Levels; Check Position Of Wheels And Wheel Lockout Butterflies And Wheel Lockpins; Check Drag Stake Adjustment - Ardisam GARDEN STAR 5020D Operator's Manual

OPERATION AND TILLING TIPS

Section Checklist
CAUTION
Please do not start your tiller until you have
read the Manual that came with your engine,
and the sections in this manual titled Controls
and Adjustments and Safety. If you have read
these, follow the steps below to start your tiller.
Always perform this pre-start checklist before
starting the engine.
❒ ❒ ❒ ❒ ❒ Check Oil and Gas Levels
CAUTION
Never add gas when engine is running or hot
from operation. Never fill the tank indoors.
IMPORTANT
The engine is shipped without oil. YOU MUST ADD
ENGINE OIL BEFORE STARTING ENGINE.
❒ ❒ ❒ ❒ ❒ Check Position of Wheels,
Wheel Lockout Butterflies
and Wheel Lockpins
❒ ❒ ❒ ❒ ❒ Check Drag Stake
Adjustment

❑ Check Oil and Gas Levels

❑ Check Position of Wheels, Wheel Lockout Butterflies and
Wheel Lockpins

❑ Check Drag Stake Adjustment

❑ Start the Engine
❑ Tilling
❑ Turning
❑ Tilling Tips
❑ Cultivating
1. If you did not already add oil, add it now by following instructions
on pages 13-14. Always check oil level before starting engine.
2. If necessary, add fuel. Use clean, fresh, lead-free gasoline with a
minimum of 77 octane. (Refer to your engine manual for further
information on fuel.)
Wheels must always be locked in the TILLING
position when engine is running. Do not
operate the tiller without the wheel lockout
butterflies or wheel lockpins installed or with
the wheel lockout butterflies or with the wheel
lockpins unlocked. Always set the wheels in
tilling position before starting engine.
Always put the drag stake in the transport
position before starting engine. Tines should
clear the ground.
19
CAUTION
CAUTION
ARDISAM