Buick Enclave 2008 Owner's Manual page 89

There are other conditions which can affect the
performance of the transmitter, see Remote Keyless
Entry (RKE) System on page 2-4 for additional
information.
/
(Remote Start): This button will be on the RKE
transmitter if you have remote start.
To start the vehicle:
1. Aim the transmitter at the vehicle.
2. Press and release the transmitter's lock button,
then immediately press and hold the transmitter's
remote start button until the turn signal lights flash.
If you cannot see the vehicle's lights, press
and hold the remote start button for at least
four seconds. The vehicle's doors will lock.
Pressing the remote start button again, after
the vehicle has started, will turn off the ignition.
When the vehicle starts, the parking lamps will turn
on and remain on while the vehicle is running.
3. If it is the first remote start since the vehicle has
been driven, repeat these steps while the engine
is still running, to extend the time by 10 minutes
for the engine to continue to run. Remote start
can be extended one time.
2-8
After entering the vehicle during a remote start, insert
and turn the key to the ON/RUN position to drive
the vehicle.
If the vehicle is left running it will automatically shut
off after 10 minutes unless a time extension has
been done.
To manually shut off a remote start:
•
Aim the RKE transmitter at the vehicle and press
the remote start button until the parking lamps
turn off.
•
Turn on the hazard warning flashers.
•
Turn the ignition switch on and then off.
The vehicle can be started using the remote start
feature two separate times between driving sequences.
The engine will run for 10 minutes after each remote
start.
Or, you can extend the engine run time by another
10 minutes within the first 10 minute remote start time
frame, and before the engine stops.