Related Manuals for Clarke ETC8
Summary of Contents for Clarke ETC8
- Page 1 WARNING: Read these instructions before using the machine ELECTRIC TILE CUTTER MODEL NO: ETC8 PART NO: 3400515 OPERATION & MAINTENANCE INSTRUCTIONS LS0711...
-
Page 2: Specifications
GUARANTEE This CLARKE product is guaranteed against faulty manufacture for a period of 12 months from the date of purchase. Please keep your receipt as proof of purchase. -
Page 3: Safety Precautions
SAFETY PRECAUTIONS WARNING: READ ALL INSTRUCTIONS. FAILURE TO FOLLOW ALL INSTRUCTIONS LISTED BELOW MAY RESULT IN ELECTRIC SHOCK, FIRE AND/ OR SERIOUS INJURY. THE TERM “POWER TOOL” IN ALL WARNINGS LISTED BELOW REFERS TO YOUR ELECTRIC TILE CUTTER. WORK AREA 1. -
Page 4: Environmental Protection
5. Dress properly. Do not wear loose clothing or jewellery. Keep your hair, clothing and gloves away from moving parts. Loose clothes, jewellery or long hair can be caught in moving parts. POWER TOOL USE AND CARE 1. Do not force the power tool. Use the correct power tool for your application. -
Page 5: Additional Safety Rules For Your Tile Cutter
ADDITIONAL SAFETY RULES FOR YOUR TILE CUTTER 1. Remove the mains plug from socket before carrying out any adjustment or servicing. 2. If the supply cord is damaged have it replaced by a qualified person. 3. Always wear both eye and ear protection when using the machine. 4. -
Page 6: Electrical Connections
ELECTRICAL CONNECTIONS WARNING: READ THESE ELECTRICAL SAFETY INSTRUCTIONS THOROUGHLY BEFORE CONNECTING THE PRODUCT TO THE MAINS SUPPLY. Before switching the product on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate. This product is designed to operate on 230VAC 50Hz. -
Page 7: Fitting The Blade Guard
ASSEMBLY WARNING: BEFORE USING YOUR TILE CUTTER BE SURE TO READ THE INSTRUCTION MANUAL CAREFULLY. FITTING THE BLADE GUARD 1. Loosen the two table securing knobs (Front and rear of the unit). 2. Tilt the table. 3. Slide the blade guard into position as shown and secure using the blade guard locking screws. -
Page 8: Operation
OPERATION WARNING: BEFORE USING YOUR TILE CUTTER BE SURE TO READ THE INSTRUCTION MANUAL CAREFULLY. THE WATER Position the tray as shown and fill 3/4 full with water. • Do not add chemicals or detergents to the water. • Always maintain this level (3/4 full) to ensure that there is sufficient water in the tray for dust suppression and cooling. -
Page 9: Starting And Stopping
STARTING AND STOPPING Press the ON Button (marked “I“) to start the tile cutter. • Allow the tile cutter to reach full speed before cutting any tiles. Press the OFF Button (marked “O“) to stop the tile cutter. NOTE: The disc will continue to rotate for some time after switching off. -
Page 10: Cleaning And Maintenance
PROCEDURES, DISCONNECT THE PLUG FROM MAINS SUPPLY. CHANGING THE CUTTING DISC • Replacement discs are available from your Clarke dealer. • Only use discs with a diameter of 180 mm. • The replacement discs speed rating must meet or exceed the RPM rating of the tile cutter. -
Page 11: Declaration Of Conformity
DECLARATION OF CONFORMITY Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
Need help?
Do you have a question about the ETC8 and is the answer not in the manual?
Questions and answers