Subscribe to Our Youtube Channel
Related Manuals for Clarke ETC7
Summary of Contents for Clarke ETC7
- Page 1 ELECTRIC TILE CUTTER ELECTRIC TILE CUTTER Model No. ETC7 & ETC7SS Part Nos. 3400505 & 3400510 OPERATING & MAINTENANCE INSTRUCTIONS 0805...
- Page 2 Thank you for purchasing this Clarke Tile Cutting Machine. PARTS LIST AND DIAGRAM The ETC7 tile cutter incorporates a 180mm sintered diamond cutting disk and will make straight cuts on tiles with a maximum cutting depth of 34mm. The table may be tilted so that tiles may be cut to any angle up to 45 degrees.
-
Page 3: Declaration Of Conformity
MAINTENANCE moving parts of this high speed machine. When carrying out servicing or maintenance tasks...ALWAYS disconnect the ALWAYS use a Clarke face mask to prevent inhalation of any dust which may machine from the mains supply. be present. Always rotate the cutting disk by hand before use to check for cracks or distortion. - Page 4 INSTALLATION ELECTRICAL CONNECTIONS. Provision is made so that the Tile Cutter may be semi-permanently fixed to a workbench WARNING! or table, using suitable bolts in the two slotted holes in the base of the machine. If the power cable is worn or cut, or damaged in any way, have it replaced immediately to avoid shock or fire hazard.
Need help?
Do you have a question about the ETC7 and is the answer not in the manual?
Questions and answers