Table of Contents
Advertisement
98640A Analog Input Interface
MA TING CONNECTORS
~
THREADED HOl
~
~
A-to-D
CARD~~
~
RIGHT -ANGLE POSTS
~'
/
EXTRACTO~~~ ~
WIRE TERMINA TION ASSEMBLY
Figure 2 - 2. Installation
The A-to-D card must seat in order for the wire termination assembly to fit on the back of the com-
puter. When correctly installed the card's extractors will be folded flat against the card with one edge
of each extractor touching or almost touching the card cage.
Removal
I
CAUTION
I
The following instructions for removing the A-to-D
card assume you have properly powered -down the com-
puter and removed the wire termination assembly as ex-
plained
in
Section
5
under
the
heading
"DISCONNECTING THE WTAII. If you have not turned
the power on yet, then the instructions below apply.
2-6
Advertisement
Table of Contents
