Rear Wheel - Yamaha TT-R125E Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
1. Washer
2. Wheel axle nut
4. Pull the wheel axle out, and then
remove the wheel. NOTICE: Do
not apply the brake after the
wheel has been removed to-
gether with the brake disc, oth-
erwise the brake pads will be
7
forced shut.
[ECA11071]
To install the front wheel
(TT-R125LW/TT-R125LWE)
1. Lift the wheel up between the fork
legs.
TIP
Make sure that there is enough space
between the brake pads before insert-
ing the brake disc into the caliper.
2. Insert the wheel axle, and then in-
stall the washer and axle nut.
3. Lower the front wheel so that it is
on the ground.
4. Tighten the axle nut to the speci-
fied torque.
Tightening torque:
Axle nut:
45 Nm (4.5 m·kgf, 32 ft·lbf)
5. Push down hard on the handlebar
several times to check for proper
fork operation.
EAUW0560

Rear wheel

To remove the rear wheel
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the axle nut.
1. Wheel axle nut
2. Remove the brake pedal free play
7-32
WARNING
adjusting nut, and then disconnect
the brake rod from the brake cam-
shaft lever.
EAU25080
EAU25421
EWA10821