Prestige APS-57E Installation Manual page 13

3 Wire Positive Switched Door Lock/Unlock Wiring Detail
To Red Lock Wire
Of Control Module
To Green Unlock Wire
Of Control Module
To Red Lock Wire
Of Control Module
To Green Unlock Wire
Of Control Module
NOTE: Resistive Circuits, Multiplex Circuits As Well As 4 Wire Polarity Reversal and 5 Wire Alternating
12 Volt Door Lock Control Circuits
These applications require the use of additional components which may include relays, fixed resistor, a door
lock interface, or a data module. You can search the vehicle @ www. avxtech1.com, www.Flash-It.com for
vehcile specific information, or contact our tech service line or web site for additional information.
Additional Harnesses And Connectors For The System
4 Pin Upgrade Telematic Module:
Red = +5 Volts / Black = Ground / White = Data TX / Yellow = Data RX
Connect the 4 pin harness found in the Telematic one way or Carlink II kits to the mating port on the controlling
circuit.
NOTE: If using the TWO WAY Telematic module, only Ground, TX, and RX are used on this port, the +12
Volt supply for the two way module must be sourced separately or the unit will not operate.
6 Pin 5 Wire Antenna/Receiver Program Push-Button Switch/LED Connector:
Plug the previously routed antenna connector from the antenna receiver assemble into the mating connector
of the control module. This connector supplies 5 Volts, ground and RF data output, LED cathode, and Valet
Enable to and from the antenna receiver and the remote start module. Be certain this connector is firmly
seated making good contact to the control unit.
Unlock
(+)
When Using DLVI
Green
X
Blue
Cut and Splice
Per the Install
Guide Instruction
Factory Lock Relay
85
When Using Relays
86
85
86
Factory Unlock Relay
85
87a 87
Lock
30
86
86
87a 87
30
85
87a 87
30
To Fused + 12 Volts
87a 87
30
To Fused + 12 Volts
(Connector Port)
13
Factory Lock Relay
From Vehicle
Chassis Ground
Factory Unlock Relay
Part # 1124296
128-9312
13 of 24