Creating A Video Conference (Multisite) - Cisco C20 User Manual

Cisco TelePresence System Profile Series, Codec C Series, Quick Set C20, SX20 Quick Set, MX200, MX300
Creating a video conference
(MultiSite)
If your video system is equipped with the optional
MultiSite feature you may call more than one to initiate
a video conference.
The MultiSite feature allows you to call three other
systems on video plus a fourth system on audio only
(for example a mobile phone).
This means that the conference can consist of up to
four video participants (yourself included) and one
audio participant.
If you want to initiate a video conference, you must
call each participant one by one.
Call settings. Those you call may have video
systems with different capabilities. One or more of
them may, for example, be on an ADSL system with
limited bandwidth (compared to those of the other
participants). You may then set the Call settings to
a (normally lower) call rate suiting his or her system
before you call that person. However, that call rate will
affect that specific part of the video conference only.
Other participants will not experience a lower call rate
because of this.
See also the article "Video conferencing—calling more
than one (optional)" on page 16.
D14582.15R1 (Rev.1 Nov 2013) User guide Profile Series, Codec C Series, Quick Set C20, SX20 Quick Set,
MX200, MX300. All contents are copyright © 2010–2013 Cisco Systems, Inc. Version TC6.2, 06.2013. English
Place a call to the first
participant.
Call the next
participant in the usual
way.
Repeat the procedure from , if
needed.
A maximum four video systems
(yourself included) and one audio call
may participate.
If you initiated the conference you will be able to terminate the entire conference as well.
The other participants, however, may only disconnect themselves from the conference.
17
Once you are
in the call, tap Add.
Tap Add to place the second
call, initiating a conference. You
may adjust Call Settings before
you place the call, if needed.
Tap END to terminate the
conference.
www.cisco.com
User guide