Remote Connection - Toshiba Strata CIX40 Installation And Maintenance Manual

Table 1-9 LED Indicators on the GVPH1
Indication/ State
Power On
(Initialize Sequence*)
Normal
(Busy/Idle)
Failure
Shut Down
Back Up/Restore
No 1.8V input Voltage
in GVPH1
Not mounted/
defective
* The initialize sequence operates each time the CIX40 power is cycled off/on or the CIX40
processor is reset or initialized – GVPH1 program data remains saved. However, if the GVPH1
battery jumper is removed, GVPH1 program data and saved messages will be erased.

Remote Connection

Remote communication to the GVPH1 requires the installation of a modem on the UADM PC (if a
modem does not already exist). The GVPH1 comes equipped with an internal modem (AMDS
daughter board) of 33.6 Kbps baud and does not require any additional equipment.
UADM PC Modem
Prepare the UADM PC by installing, connecting and configuring a modem. The modem
must be capable of communicating at a minimum of 9600 baud.
CAUTION! Internal modems configured for COM ports 3 or 4 are not supported by
UADM software.
The UADM PC's modem connects to the GVPH1 through User ID 993.
Strata CIX40 Installation & Maintenance
Ch1 Ch2
All LEDs turn ON (Red), then all LEDs turn OFF and cycle ON/OFF through
all ports for one to two minutes while initializing and then all LEDs turn off.
OFF OFF
ON = Busy; OFF = Idle
Blinking Blinking
ON ON
ON ON
ON OFF
Light flickers and switches from the LED to LED (from Ch1~Ch4) + Status
LED
5/06
GVPH1 LEDs
Ch3 Ch4
OFF OFF
Blinking Blinking
ON ON
ON ON
OFF ON
CIX40 Installation
Installing the CIX40 Cabinet
Status
Blinking
OFF
OFF
ON
ON
1-21