Toshiba Strata CIX40 Installation And Maintenance Manual page 28

CIX40 Installation
Installing the CIX40 Cabinet
Step 4: Install the GIPH1 8-Channel IP Interface PCB (optional)
1. In the CIX40 cabinet, remove the two screws and the PCB stopper
2. Turn off system power. If the GCTU2 is installed remove it before installing the GIPH1.
3. Install the GIPH1 into the GMAS (sub-motherboard) (see
4. Install the GCTU2.
5. Replace the PCB stopper and secure with the oridginal two screws.
6. Turn system power ON.
Note To program GIPH1, refer to the Strata CIX Programming Manual Vol. 1 and use eManager.
Licenses are required for IP Telephone and Strata Net IP. Use eManager R4.12A05, or later, to
apply the necessary licenses to the GCTU2 for GIPH1 operations.
Figure 1-16 GIPH1 Card
1-22
(Figure 1-17).
Figure 1-12 and Figure
Reset switch
Serial port
HB LED
LAN Port
Strata CIX40 Installation & Maintenance
1-17).
Channel 8
Channel 7
Channel 6
Channel 5
Channel 4
Channel 3
Channel 2
Channel 1
5/06