Bayliner Rendezvous Owner's Manual Supplement page 19

Forward Bimini Top Installation (Option)
1. Lay the bimini top across the transom with the stanchions pointing forward.
The bowed-in (forward) stanchions should be on top.
2. Separate the front bow assembly (see point A below) from the canvas by unzip-
ping the main bow pocket (B) and the forward center bow pocket (C).
3. With one person working on each side of the boat, remove the locking pins
from the forward deck hinges (D).
4. Install the end eyes (E) of the forward bow stanchions between the lobes of the
deck hinge.
5. Reinsert the pin and make sure it goes all the way through and locks.
6. Remove the locking pins from the aft deck hinges (F).
7. Install the end eyes (G) of the aft bow stanchions between the lobes of the deck
hinges.
8. Reinsert the pin and make sure it goes all the way through and locks.
9. Remove the bimini top boot and store.
10. Pull the canvas forward, over the forward bow assembly and zip the main stan-
chion (H) into the forward bow pocket (B).
11. Zip the forward center bow braces (I) as needed to tighten the canvas.
CHAPTER 3: COMPONENTS / SYSTEMS
FORWARD BIMINI TOP COMPONENTS
Rendezvous Owner's Manual Supplement
13