Fuel System - Bayliner Rendezvous Owner's Manual Supplement

Autofloat switches should be tested often for proper operation as follows:
1. Push the float switch test
button UP to activate the
bilge pump.
If the pump does NOT
turn on, check the inline
fuse. If the fuse is good
but the switch doesn't
work, it may indicate a
bad switch or possibly a
low battery.
2. Push the test button all the
way DOWN to return the
float switch back into the
auto mode.
When the float switch test is completed, you MUST push the test button all the
way DOWN to return the switch back into auto mode!

Fuel System

Carefully read the fuel system sections of the owner's manual and the engine
operation manual.
Discharge of fuel into navigable waters is prohibited by law. Violators are
subject to legal action by the local authorities.
FIRE, EXPLOSION AND OPEN FLAME HAZARD!
• It is very important that the fuel system be inspected thoroughly the first time
it is filled and at each subsequent filling.
• The fueling instructions in the owner's manual and the fuel grade recommen-
dations in the engine operation manual must be followed.
Avoid the storage or handling of gear near the fuel lines, fittings and tank.
Fuel Fill Location
The fuel fill receptacle is located on the starboard aft deck of your boat and is
labeled "GAS". If you experience difficulty when filling the fuel tank, check to see
that the fuel fill and vent lines are free of obstructions and kinks.
CHAPTER 3: COMPONENTS / SYSTEMS
SWITCH UP - AUTO MODE;
BILGE PUMP SHOULD
TURN OFF
CAUTIO N!
!
NOTIC E
WA RNIN G!
!
CAUTIO N!
!
FLOAT SWITCH TESTING
FLOAT SWITCH
TEST BUTTON
SWITCH DOWN - AUTO MODE;
Rendezvous Owner's Manual Supplement
BILGE PUMP SHOULD
TURN OFF
9