Fireplace Location - Majestic 300DVB User Manual

DVB Series Direct Vent Gas Fireplace

FIReplAce locAtIoN

Plan for the installation of your appliance. This
the vent configuration to be used, framing and finishing details, and whether any optional accessories
(i.e. blower, wall switch, or remote control) are desired. Consult your local building code agency to ensure
compliance with local codes, including permits and inspections.
The following factors should be taken into consideration:
•
Clearance to side-wall, ceiling, woodwork, and windows. Minimum clearances to combustibles must
be maintained.
•
This fireplace may be installed along a wall, across a corner, or use an exterior chase. Refer to Figure
3 for suggested locations.
•
Location should be out of high traffic areas and away from furniture and draperies due to heat from
appliance.
•
Never obstruct the front opening of the fireplace.
•
Do not install in the vicinity where gasoline or other flammable liquids may be stored.
•
Vent pipe routing. See Venting section found in this manual for allowable venting configurations.
•
These units can be installed in a bedroom. See National Fuel Gas Code ANSI Z33.1/NFPA 54
— (current edition), the Uniform Mechanical Code — (current edition), and Local Building Codes for
specific installation requirements.
E
Y
D
Y
F
Figure 3 -
Fireplace Locations
8
A
X
C
LU584-1
Locating unit
2/4/99 djt
includes determining where the unit is to be installed,
A Flat on Wall
B Cross Corner
C Island**
D Room Divider*
B
E Flat on Wall Corner*
F Chase Installation
Y 4" Minimum
** Island (C) and room divider (D) installation is possible as long
as the horizontal portion of vent system (X) does not exceed
0'. See Installing Horizontal Termination Configuration on
B
Pages 18 and 19.
* When you install your fireplace in (D) room divider or (E)
flat on wall corner positions (Y), a minimum of 6" clearance
must be maintained from perpendicular wall and front of
fireplace.
pRe-INstAllAtIoN INFoRMAtIoN
54D0701