Installing The Tablet Into An Existing Anypoint™ Wireless Home Network - Intel Web Tablet Product Manual

Installing the Tablet into an Existing AnyPoint™
Wireless Home Network
Use the following steps if this is your first tablet and you already
have an AnyPoint™ Wireless Home Network installed.
The tablet is not designed to be compatible with an
Note:
AnyPoint Phoneline Home Network. For details, check the
Technical Issues available in the tablet's Info Center and at
www.intel.com/home/webtablet/support
Begin Charging the Tablet
1 Remove the plastic pull-tab from the battery case on the
rear of the tablet to activate the battery.
2 Plug the AC adapter into the wall. Open the tablet access
panel on the side of the tablet and plug the adapter into the
tablet's AC power jack.
3 Leave the tablet connected to AC power so it can begin
charging while you complete the tablet setup. The entire
installation process takes approximately 45 minutes.
If you use the flip stand on the back of the tablet to keep
Note:
the tablet upright, make sure the stand is fully extended.
Install the Tablet Software on the Server PC
Important: Because the tablet will use your existing Intel
!
AnyPoint wireless home networking software to
communicate with the Internet, you must install the tablet
software on your AnyPoint Home Network's
If you purchased an Intel Web Tablet that includes a
wireless USB adapter, do NOT install the new adapter on
the server PC. The tablet will use your existing AnyPoint
Wireless Home Network's adapter to communicate with
the PC.
.
server PC .
1 At the server PC,
insert the Intel
the CD-ROM drive .
2 From the Windows* desktop, open
double-click the CD-ROM drive.
3 Double-click
setup.exe.
appears.
4 Click to begin installing the tablet software.
Install
5 If you are using a version of the AnyPoint software that is
earlier than the one on the tablet's Setup CD, you will be
asked if you want to upgrade.
• To continue with the tablet installation, you must click
. Setup will start the AnyPoint software upgrade.
Yes
• If the AnyPoint Internet Sharing Software (ISS) is
running, click when prompted to shut it down.
OK
• When your PC restarts after the upgrade, continue with
the tablet installation. If the tablet setup program does
not restart on its own, repeat steps 2-4 above
Follow the on-screen instructions to install the software
1 The Setup Wizard shows several screens and displays your
existing AnyPoint network code.
Write down the network code in the space provided below.
You will need this network code to set up the tablet.
Write your network code here:
For more information about the network code, click
the Setup Wizard screen.
®
Web Tablet Setup CD into
My Computer and
The Intel Web Tablet Setup screen
.
Help
INSTALLATION – SPECIAL CASES |
on
23