Installing The Tablet And The Anypoint™ Network Drivers For The First Time - Intel Web Tablet Product Manual

Installing the Tablet and the AnyPoint™ Network
Drivers for the First Time
Use the following steps if this is your first tablet and you do not
already have an AnyPoint™ Wireless Home Network installed
on your PC.
Begin Charging the Tablet
1 Remove the plastic pull-tab from the battery case on the
rear of the tablet to activate the battery.
2 Plug the AC adapter into the wall. Open the tablet access
panel on the side of the tablet and plug the adapter into the
tablet's AC power jack.
3 Leave the tablet connected to AC power so it can begin
charging while you complete the tablet setup. The entire
installation process takes approximately 45 minutes.
If you use the flip stand on the back of the tablet to keep
Note:
the tablet upright, make sure the stand is fully extended.
Install the Wireless Adapter (On the PC)
1 Shut down and turn off the PC.
2 Plug the AnyPoint adapter cable into an open USB port.
3 Turn on the PC.
4 After the PC starts up,
CD into the CD-ROM drive
20
| INSTALLATION – SPECIAL CASES
insert the Intel ® Web Tablet Setup
.
Install the Drivers (On the PC)
Important! Do NOT click Cancel
New Hardware wizard.
1 When the Add New Hardware wizard starts, click
begin installing the drivers.
2 Select
Search for the best driver for your device
Next .
3 If you are prompted for a drive, make sure the
check box is checked. Click
drive
drivers.
4 Click .
Finish
5 If you are prompted to restart the PC, click
asked to restart the PC more than once – click
6 On Windows* 98 systems, you may need to click
again.
Install the Tablet Software (On the PC)
After the drivers are installed, the Intel Web Tablet Setup screen
appears.
If the Intel Web Tablet Setup screen does not appear, open
Note:
on your desktop. Double-click the CD-ROM
My Computer
drive, and then double-click setup.exe.
1 Click to begin installing the tablet software.
Install
2 Follow the on-screen instructions to install the software.
on ANY screen in the Add
to
Next
and click
CD-ROM
twice to install the
Next
No . You may be
each time.
No
Finish