Troubleshooting Installation Problems - Intel Web Tablet Product Manual

Troubleshooting Installation Problems

If You Exit Setup Before All Steps Are Completed...
If you exit Setup before all the installation steps are complete,
you can continue the installation later. To restart installation
later:
1 Place the Intel
drive.
2 At the Windows* desktop, go to
click the CD-ROM Drive.
3 Double-click
If possible, Setup will begin at the point where you exited.
Follow the instructions on the screens to complete the setup.
If Setup Detects More than One Adapter on the PC...
If you receive an error message telling you that the PC has an IP
address conflict, it means the PC has a network adapter with an
IP address that conflicts with the AnyPoint™ adapter's IP
address.
The Suggested IP information
address and Subnet mask for the AnyPoint wireless adapter.
• To accept the suggested address, click
• To find a different IP address for the wireless adapter, click
the
Suggest New Address
The Setup program will continue. Follow the instructions on the
installation poster or in this chapter to complete setting up the
tablet.
28
| INSTALLATION – SPECIAL CASES
® Web Tablet Setup CD into your CD-ROM
My Computer
setup.exe .
box displays an alternate IP
Next
button, and then click
If You Receive Dial-up Networking Errors...
If you receive the following error during setup:
"You have Dial-up Networking installed but it is not
configured to use any ISPs. Please configure Dial-up
Networking before running the connection wizard again."
Do the following:
1 Follow the instructions from your Internet Service Provider
(ISP) to set up your PC Internet connection.
and double-
2 After the connection is set up and working, open the
Windows
Tablet > Tablet Connection Wizard
Connection Wizard appears.
3 Follow the directions on the Wizard screens to set up the
tablet to use your dial-up connection.
If You Cannot Read the Text on the Tablet Screen...
If you have difficulty reading the tablet screen when you start
setting it up (before the standard controls for adjusting contrast
and brightness are available), you can adjust the touch screen
contrast at the beginning of tablet setup.
Do the following:
.
1 Make sure the tablet is displaying the first screen,
to the Intel Web Tablet
.
Next
2 Rock the back/forward button in succession – right to
increase contrast, left to decrease contrast.
Once you complete tablet setup, use the control panel to further
adjust contrast or brightness.
menu, and then select
Start Programs > Intel Web
. The Intel Web Tablet
.
Welcome