Four winns Vista 328 Owner's Manual page 55

sible damage to the steering cable. If unable to locate or
correct the problem, have the steering cable inspected
and lubricated by your Four Winns dealer.
After the first two hours of running time, check
the entire steering system for loose bolts, nuts
and fasteners which could adversely affect steer-
ing control.
NOTICE
Check the fluid level in the reservoir periodically.
Low power steering fluid levels may increase
steering difficulty.
NOTICE
DO NOT interfere with or restrict steering cable
movement through the last 90
engine. DO NOT use cable retainers, clamps or
tie straps. Using one or all of these could re-
strict the cable movement near the engine. DO
NOT tie wiring harnesses or other control cables
to the steering cable. Make sure the deck
coaming pads and bulkheads allow for steering
cable movement in all positions of trim.
When storing equipment in the engine compart-
ment, be sure to avoid contact with the steering
cable. Cables may become kinked or damaged
and may increase steering effort.
Additional information on steering operation can be found
in Section A-9 in this manual and in your Engine Owner's
manual.
Steering effort can vary significantly with engine
acceleration, steering angle, trim angle, and sea
condition. Be prepared for additional steering
loads at all times.
G - 2 STEERING SYSTEM MAINTENANCE
A periodic inspection of all steering cables, linkage and
helm assemblies should be made. Signs of corrosion,
cracking, loosening of fastenings, excessive wear, or de-
terioration should be immediately corrected. Failure to
do so could lead to steering system failure and corre-
sponding loss of control.
298/328 Vista Owner’s Manual
09/00
The helm and cable assembly should be so adjusted that
the steering wheel is centered with the drives in the straight
ahead position. There should be an equal number of turns
to port and starboard from the straight ahead position. If
adjustment becomes necessary, see your Four Winns
dealer.
All cables, helm assemblies, and steering connections
should be periodically lubricated with a light, waterproof
grease or as indicated in the manufacturer’s information
provided.
of bend at the
o
Section G
Page 2