Table of Contents
Advertisement
Bluetooth Sync
Bluetooth Boot
EQ Presets
Mic/Line Button
XLR-1/4" Combo Inputs
XLR Male Loop Thru
Power Switch
POWER IT ON
1.
Confirm the Power Button (I) is in the OFF position.
2.
Connect the supplied power cord to the power receptacle on
the rear of the speaker.
3.
Connect the power cord to an available power outlet.
4.
Flip on the Power Switch (G) and press the Power Button (I) to
ON position, the White Power LED (H) on back and front of the
speaker will illuminate
BLUETOOTH
A
SYNC
BOOT
B
MAIN
EQ
PRESETS
MONITOR
C
SUB
SPEECH
EON 615
SIGNAL
LIMIT
GAIN
D
MIC
MASTER
CH1
LINE
VOLUME
E
IN 1
F
THRU
MODEL: EON615
SERIAL NO:
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE.
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
G
430W Max
100-120VAC 50/60Hz
230-240VAC 50/60Hz
FUSE TYPE: T3.15L250V
FOR CONTINUED PROTECTION AGAINST RISK OF FIRE, REPLACE FUSE ONLY WITH SAME TYPE OF RATING.
QUICK SETUP GUIDE
POWER
Front LED On/Off
H
Power Button
I
ON
OFF
FRONT LED
EQ +
EQ+ On/Off
J
CH1 & CH2 Gain
K
SIGNAL
Limit LED
L
GAIN
MIC
CH2
LINE
Master Volume
M
IN 2
Made in
Mexico
JBL PROFESSIONAL
NORTHRIDGE, CA. USA
A HARMAN INTERNATIONAL COMPANY
DESIGNED AND ENGINEERED IN THE USA
PLUG IN THE INPUTS
1.
Turn Channel Gain Controls (K) and Master Volume
Control (M) all the way to the left before connecting
any inputs
2.
Connect XLR or TRS cable from audio source to CH1
or CH2 inputs (E)
3.
Select Mic or Line via the Mic/Line Button (D)
SET OUTPUT LEVEL
1.
Using the EQ Preset (C) button, select the appropriate
preset to match your application
2.
Set the gain level for the input using the Channel Gain
(K) controls. A good starting point is to set the pot at
12 o'clock.
3.
Slowly turn Master Volume (M) to the right until the
desired volume is reached.
7
Hide quick links:
Advertisement
Table of Contents
