Sea-doo GSX Limited Shop Manual page 22

Section 01 ENGINE
Subsection 03 (BOTTOM END)
1
F06D1FA
1. Separate halves by prying at provided lugs (both sides)
Remove crankshaft and counterbalance shaft.
14, Crankshaft
NOTE: Do not needlessly remove crankshaft
bearings.
Remove end seals no. 1.
1
F06D1GA
1. End seal (MAG side)
To remove end bearings no. 15 from crankshaft,
use the following tools:
01-03-4
6 1
6
F06B03A
1. Puller (P/N 420 877 635)
2. Protective cap (P/N 290 877 414)
3. Distance ring (P/N 290 876 569)
4. Ring (P/N 290 977 480)
5. Ring halves (P/N 290 876 330)
6. Screw (P/N 290 940 755)
NOTE: To facilitate ring or distance ring installa-
tion, lubricate their inside diameters.
Or, use a bearing extractor such as Proto no. 4332
and a press to remove 2 bearings at a time.
1
F01D1PA
TYPICAL
1. Press bearings out
2. Bearing extractor
16, Counterbalance Shaft
NOTE: Do not needlessly remove counterbalance
shaft bearings.
Use a press to remove counterweights no. 17
and bearings no. 18.
-
There is no woodruff key to position the
counterweights. An index mark must be
traced to retain the proper position of the
counterweight.
www.SeaDooManuals.net
3 4
2
2
CAUTION
5