Table of Contents
Advertisement
PROGRAMMING BANK 1 (TRANSMITTERS):
1) Turn the ignition key to the ON position.
2) Press and release the valet/programming switch 3 times (Siren Chirps).
3 Press the Lock Button of each transmitter you want programmed until you hear a chirp from the horn or siren.
4) Turn the ignition switch off.
The above action programs the Lock, Unlock, and Start/Trunk,buttons of the system. For additional channel pro-
gramming from step 2 above:
1) Press the valet/programming button 3 additional times to access channel 4.
2) Press the Option 1 Button of each transmitter you want programmed until a chirp is heard from the siren.
3) Press the valet/programming button 1 additional time to access option channel; 5.
4) Press the Option 2 button of each transmitter you want programmed until a chirp is heard from the siren.
PROGRAMMING BANK 2 (ALARM FEATURES):
You can enter bank 2 from bank 1 by turning the ignition key off then on from step 4 of Bank 1.
(Siren Short then Long Chirp), or You can also go right to bank 2 by:
1) Turn the ignition key to the ON position.
2) Press and release the valet/programming switch 3 times (Siren Chirps).
3) Turn the ignition key off then on. (Siren Short Then long Chirp)
4) Press the pushbutton switch once to advance to feature 1, twice to advance to feature 2, etc,,,then use the lock
button of the transmitter to select the feature setting.
Example to set passive arming:
1) Turn the ignition key to the on position.
2) Press and release the valet/programming switch 3 times (Siren Chirps).
3) Turn the ignition key off then on. (Siren Short Then long Chirp)
4) Press the pushbutton switch six times to advance to features 6, Pass/Act Arm, then use the lock button of the
transmitter to select two chirps "Passive Arm".
5) To exit the programming mode, turn the ignition key off.
The selectable features of this unit can be set manually as explained above, or on-line by using our web link. The
Accessory VE-PROG kit will include the necessary cables to connect to your computer along with the web access
information and application required to take advantage of this feature.
If Programming via PC while connected to + 12 VDC, (Already Installed), you must manually enter the program-
ming mode as shown below:
Turn the ignition on
Press and release valet switch 3 times
Turn ignition off then on, off then on, off then on, off then on to enter web/on-line feature selection Bank 5.
Siren chirps 5 times indicating access to feature program mode. Launch the application on your PC,connect the
module via the USB to DBI harness and follow program prompts.
Page 14
128-9316
14 of 16
Hide quick links:
Advertisement
Table of Contents
