Advertisement
Quick Links
With Start Inhibit and Dual Stage Shock Sensor
COMPONENTS:
1 Control Module
1 Four Button RF Transmitter
1 Four Button LCD Transmitter
2 Way Antenna/Receiver
1 1" X 1.75" Foam Pad
14 Pin Accessory Harness
1 Hood Pin Switch
1/4" Female Spade Connector
FEATURES:
Four Channel Receiver (Capable Of Accepting Up To 4 Transmitters)
Code Hopping Technology
Selectable Manual Override Mode
Remote Panic in all modes
Protected Valet
User Programmable Manual Override Code
7 Function LED (Light Emitting Diode) - Arm / Disarm / Zone 1, 2, 3 / Valet / Arming
Intrusion Alert with Memory
Audible Arm / Disarm / Defective Zone / Tamper Confirmation
Instant Siren Activation
Starter Disable
Additional Engine Immobilizer Output (optional relay required)
True Last Door Arming (hardwire only)
Defective Zone By-Pass
Active or Passive Arming Selectable
Programmable Auto Lock On / Off
Programmable Auto Unlock On / Off
Programmable Door Lock Pulse Duration
Programmable Active or Passive Door Locks
User Programmable Permanent Chirp Delete
On Command RF Chirp Delete from Transmitter
6 Tone Multi Tone Siren
RF Inhibit with ignition on
Parking Light Flasher
Plug In Dual Stage Shock Sensor
Illuminator Entry Output (optional relay required)
FCC NOTICE
This device complies with part 15 of the FCC rules. Operation of this device is subject to the
following conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Caution: Changes or modifications not expressly approved by the party responsible for
compliance voids the users authority to operate this device.
Two Way Remote Alarm System
2 Pin Door Lock/Unlock Harness
Starter Inhibit Relay & Harness
2 Pin LED Assy
2 Pin Push-Button Valet/Program Switch
4 Pin Antenna Receivers Harness
Installation/Owners Guide
4 Phillips Head Black Drill Point Sheet
Metal Screw #8 X 1/2"
2 Stage Shock Sensor w/Harness
1
Model APS-520
Installation Manual
128-8147
1 of 8
Advertisement
Related Manuals for Prestige APS-520
Summary of Contents for Prestige APS-520
- Page 1 Model APS-520 Installation Manual Two Way Remote Alarm System With Start Inhibit and Dual Stage Shock Sensor COMPONENTS: 2 Pin Door Lock/Unlock Harness 1 Control Module Starter Inhibit Relay & Harness 1 Four Button RF Transmitter 2 Pin LED Assy...
- Page 2 INSTALLATION OF THE MAJOR COMPONENTS: CONTROL MODULE: Select a mounting location inside the passenger compartment (up behind the dashboard). The mounting location selected must be within 24" of the ignition switch wiring harness to allow connection of the 6 pin main wiring harness. Be certain that the chosen location will not interfere with proper operation of the vehicle.
-
Page 3: Shock Sensor
behind the hood seal. In both cases the switch must be set up to allow the hood to depress the switch at least 1/4 inch when the hood is closed and fully extended when the hood is opened. For direct mounting, a 1/4 inch hole must be drilled. Carefully check behind the chosen location to insure the drill will not penetrate any existing factory wiring or fluid lines. - Page 4 switches. In most cases the Brown wire will need to be connected to only one door switch no matter how many doors the vehicle has as most door lighting circuits are wired in parallel. This wire will be shunted when remote starting the vehicle and will remain shunted, if active, while running under command of the remote start.
- Page 5 2 Pin LED Harness, Connector Route the twin lead Red and Blue wires from the LED to the remote start control unit and plug the two pin connector into the mating white mini connector on the control module. These wires control the anode and cathode of the dash mounted LED.
- Page 6 OTHER DOOR LOCKING CIRCUITS ARE SHOWN IN THE FOLLOWING DIAGRAMS: 128-8147 6 of 8...
-
Page 7: Completing The Installation
Setting Up The System Programming Features: Bank 1 Transmitter Channels: 1. Start with the system disarmed; turn the ignition switch to the on position; then press and release the pushbutton valet/program switch 3 times. Siren Chirps once and or Lights flash one time indicating the transmitter program mode successfully entered. - Page 8 © 2007 Audiovox Electronics Corporation, 150 Marcus Blvd., Hauppauge, N.Y., 11788 128-8147 128-8147 8 of 8...