Table of Contents
Advertisement
Address: Default address is 1.
Baud rate: Select corresponding baud rate. Default value is 9600.
Data bit: Select corresponding data bits. Default value is 8.
Stop bit: Select corresponding stop bits. Default value is 1.
Parity: There are three options: odd/even/none. Default setup is none.
If you are connecting to network PTZ, the PTZ type shall be remote. See Figure 5-69.
After completing all the setting please click save button.
In one window display mode, right click mouse (click "Fn" Button in the front panel or click "Fn"
key in the remote control).
Click Pan/Tilt/Zoom, the interface is shown as below. See Figure 5-70.
Here you can set the following items:
Step: value ranges fro 1 to 8.
Zoom
Focus
Iris
Figure 5-68
Figure 5-69
116
Advertisement
Table of Contents
