Fasten The Air-Valve; Draining The Spa - Bestway Lay-Z-Spa 54113 Monaco Owner's Manual

NOTE: When performing chemical maintenance, active the
Lay-Z-Massage function to quickly dissolve chemicals into
the water. Do not use spa during chemical maintenance.
NOTE: Remove the chemical floater from spa when the spa is in
use.
After performing chemical maintenance and before using the spa,
use a test kit (not included) to test the water chemistry. pH lower
7.2 and over 7.8 will damage to the spa and pump. We recommend
maintaining your water pH between 7.2 and 7.8, total alkalinity
between 80 and 120ppm and free chlorine between 3 to 5ppm.
Damage resulting from chemical imbalance is not covered by the
Fasten the Air-Valve (For #54113 Only)
When the spa is in use it is normal for internal air pressure to
expand and/or contract. When this occurs, air may leak from the
air-valve on the spa wall. Always check the air-valve carefully
before use. If air is leaking, use the provided wrench to fasten the
air-valve following these steps:
• Open the cap of the air-valve and put the wrench into the valve
body.
• With one hand, hold the backside of the air-valve from the inner
side of the spa wall and turn the wrench clockwise.

Draining the Spa

1.
Remove the filter set from
the spa.
5.
Connect the hose
adapter to your garden
hose and attach the hose
adapter to the spa's B adapter.
9.
Use the inflation hose to blow dry
the pump and the spa pool. Connect
the inflation hose to adapter A on the pump
and press the Lay-Z-Massage button to
activate the blower.
A
NOTE: Drawings for illustration purpose only. May not reflect actual product. Not to scale.
2.
Insert the 2 stopper caps
onto the spa's inlet and outlet
pipes.
6.
With your hose
positioned in a
selected drain area, remove
the lower stopper cap from
inside the spa to release the
water.
10.
housing using a towel. Tilt the pump to drain the
residual water in the hose. It is recommended to
use the inflation hose to aim to dry the Pump's
adapter B.
warranty.
All spas require the use of pool chemicals. Pool chemicals are
potentially toxic and should be handled with care. There are
serious health risks from chemical vapors and the incorrect
labeling and storage of chemical containers. Please consult
your local pool supply retailer for more information about
chemical maintenance. Pay close attention to the chemical
manufacturer's instructions. Spa damage resulting from misuse
of chemicals and mismanagement of spa water is not covered
by the warranty.
NOTE:
1. Do not over tighten.
2. Always check the air-valve carefully before use.
3. Do not adjust the air-valve connector when the
spa is in use
3.
Disconnect the pump
from the spa.
7.
Once most of the
spa water is drained,
open the bottom drain valve
on the pool floor to remove
any remaining water.
Make sure the pump is dried
thoroughly. Clean the pump's inner
C
A
9
4.
Screw the adapter
cover onto adapter A
of the spa.
8.
Vegas (#54112):
Unscrew the
valves to deflate the
spa.
8.
Monaco (#54113): To deflate,
unscrew the air-valve counter
clockwise from the air intake
valve, press the
spring valve and
turn clockwise.
11.
Use a new filter
cartridge when
resuming spa use. Please refer
to page 8 for Filter Cartridge
Replacement.
S-S-001409