Table of Contents
Advertisement
6.1 Handling load meter
REMARK
When the bucket is tilted back fully and the lift arm is raised
above the travel posture, the measurement of the load starts. If
the first load is not discharged in Step 1, and the lift arm is low-
ered to the travel posture, then raised again to the horizontal
position, the load will be measured as the second load, even
though it has not been discharged. In this case, the bucket load
display will show 5.1t, and the total load display will show 10.2.
To cancel the mistaken second load data, press the load meter
cancel switch. The measurement is cancelled and the total load
display returns to 5.1. It is possible to cancel the measurement
15 seconds after the load is displayed or before measuring the
next load.
3. Fill the bucket with the second load, tilt the bucket back fully,
raise the lift arm above the horizontal position, then load the
dump truck.
Let us take the load in this case as 4.9t.
The display shows the bucket load as 4.9t, and the total load
display shows 10.0.
When 15 seconds have passed since the start of the mea-
surement, the bucket load display goes out and returns to
0.0t. The total load display shows 10.0.
Repeat Step 3 for the third and following loads. The total
load display shows the total amount that has been loaded.
6-22
Attachments, Options
GK050059
GK050287
GK050306
WA500-6H – VEAM430100
Hide quick links:
Advertisement
Table of Contents
