Electrical Connection - Travis Industries 864 HO NB Installation Manual

16

Electrical Connection

 The electrical line to the grounded receptacle inside the fireplace must be installed by a qualified
installer and must meet all local codes.
 Make sure the household breaker is shut off prior to working on any electrical lines.
 The appliance, when installed, must be electrically grounded in accordance with local codes or, in the
absence of local codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical
Code, CSA C22.1.
 The electrical line must be a min. 14 gauge, and supply 120 Volts, 60 Hz, and 5.7 Amps.
 Route the electrical connection through the junction box cover plate and attach to the hookup wires
pictured below.
Label all wires prior to disconnection when servicing controls. Wiring errors can cause
Caution:
improper and dangerous operation.
Do not connect 110-120 VAC to the gas control valve or wiring system of this fireplace.
a
© Travis Industries
Installation
(for qualified installers only)
b
c
4120327
d
100-01290_000