Pc500Rk Keypad - DSC PC51O Instruction Manual

PC500RK KEYPAD

The "Ready" light will come ON when the
system is ready to be armed. When the "Ready"
light is OFF, there is an open zone on the
system. The zone must be closed or bypassed
before the system can be armed. If the "Ready"
light is OFF and none of the Zone Lights are
ON, the Tamper Zone has
been activated.
The "Armed" light will come
ON to indicate that the
system is armed.
"Armed" light will FLASH to
indicate that the system is
armed and that there is no
Entry Delay on any of the
zones.
The "System" light will come
ON to indicate:
• that zones are bypassed
• there is a trouble condition
on the system
• there are alarms in
memory.
∗
Use the [ ][1][Access Code]
command to display the
zones that have been
bypassed; be sure that zones
are intentionally bypassed
before arming the system.
∗
Use the [ ][2] command to
display any trouble
conditions; be sure to have
trouble conditions corrected
by your installer as soon as
possible.
Important:
Follow the instructions in the manual to test your system weekly. Follow the
guidelines for correcting system trouble conditions; have any system trouble
conditions you cannot correct yourself attended to by your installer.
8 8
1
2
3
The
4
To View Bypassed Zones:
Enter [ ][1][Access Code]. Press [#]
to return to "Ready".
To View Alarm Memory:
Enter [ ][3]. Press [#] to return to "Ready".
To Perform a Bell Test:
Enter [ ][4].
To turn the Door Chime On and Off:
Enter [ ][6].
To program Access Codes:
Enter [ ][5][Master Code] and [number of
code to program] and [new 4-digit code].
Press [#] to return to "Ready".
Test system regularly.
Refer to Instruction Manual
for testing instructions.
F A
NOT NOT
IN IN
USE USE
PC500RK
∗
Use the [ ][3] command to view the alarms in memory.
Press [#]:
• when an error is made in entering an Access Code, then enter the code
again
• to return to "Ready" after using [
[F] Key: Press and hold this key for 2 seconds to sound an [F] Key alarm
[A] Key: Press and hold this key for 2 seconds to generate an [A] Key alarm
[P] Key: Press and hold this key for 2 seconds to generate a [P] Key alarm.
These keys must be enabled by your Installer before they
become functional. Your Installer will tell you how these
Zone Lights 1 to 4 indicate zone activity. When a
zone is secure, its Zone Light will be OFF; when a
zone is open, its Zone Light will be ON. If a zone
goes into alarm when the system is armed, the
alarm will be indicated on the zone lights until the
system is disarmed.
F A
P
NOT
IN
USE
∗
keys operate on your system.
Ready
Armed
System
Zone 1
Zone 2
Zone 3
Zone 4
P
] commands