Onchip Ide Device - SOYO SY-P4I875P DRAGON 2 User Manual

BIOS Setup Utility

3-1.3 OnChip IDE Device

Caution: Change these settings only if you are already familiar
with the IDE settings.
The [OnChip IDE Device] option changes the settings of the 82801EB
(ICH5) IDE controller. These settings do not influence the HighPoint 372N or
Silicon Image Sil3112 controllers.
The following screen shows setup default settings.
IDE 1,2 /SATA 1,2
IDE HDD Block Mode
IDE DMA transfer access
On-Chip Primary PCI IDE
IDE Primary Master PIO
IDE Primary Slave PIO
IDE Primary Master UDMA
IDE Primary Slave UDMA
On-Chip Secondary PCI IDE
IDE Secondary Master PIO
IDE Secondary Slave PIO
IDE Secondary Master UDMA
IDE Secondary Slave UDMA
*** On-Chip Serial ATA Setting ***
On-Chip Serial ATA
x Serial ATA Port0 Mode
x Serial ATA Port1 Mode
:Move Enter:Select
F5:Previous Values
After you have completed the changes, press [Esc] and follow the instructions
on your screen to save your settings or exit without saving.
Phoenix – Award BIOS CMOS Setup Utility
OnChip IDE Device
IDE only
Enabled
Enabled
Enabled
Auto
Auto
Auto
Auto
Enabled
Auto
Auto
Auto
Auto
Disabled
Primary Master
Primary Slave
+/-/PU/PD:Value
F6:Fail-Safe Defaults
SY-P4I875P DRAGON 2
Menu Level
[Disabled]: Disabled SATA
Controller.
[Auto]: Auto arrange by
BIOS.
[Combined Mode]: PATA
and SATA are combined.
Max. of 2 IDE drives in each
channel.
[Enhanced Mode]: Enable
both SATA and PATA. Max.
of 6 IDE drives are
supported.
[SATA Only]: SATA is
operating in legacy mode.
F10:Save ESC:Exit
61
Item Help
F1:General Help
F7: Optimized Defaults