STRIKEMASTER Mora Owner's Manual

Hand auger

HAND AUGER

Lazer

Synthetic

Ultra-lite

It is recommended that

everyone who uses this product

read the StrikeMaster Hand Auger

Owner's Manual.

Owner's Manual

Lazer

ATTENTION: PRIOR TO FIRST USE

CHECK BLADE SCREWS BEFORE

AND AFTER EACH USE TO MAKE

SURE THEY ARE TIGHT.

Mora

For best results exert firm

pressure downward.

ATTEMPT TO FORCE AUGER

TO CUT.

If auger does not "Bite"

on contact with the ice, check

for dull or damaged blades.

DO NOT

SM13

Table of Contents

Need help?

Do you have a question about the Mora and is the answer not in the manual?

Page 1 For best results exert firm everyone who uses this product AND AFTER EACH USE TO MAKE pressure downward. DO NOT read the StrikeMaster Hand Auger SURE THEY ARE TIGHT. ATTEMPT TO FORCE AUGER Owner’s Manual. TO CUT. If auger does not “Bite”...
Page 2 ® until they become dull or damaged. If dull or not too severely damaged, the blades on the Mora hand augers can be hand honed to extend blade life. When this procedure no longer works, replacement blades can be purchased at www.strikemaster.com.
Page 3 6. After use, the auger blades should be wiped dry and oiled to extend auger life. ® 7. The manufacturer recommends that all StrikeMaster hand augers be used for ice cutting only. 8. CHECK BLADE SCREWS BEFORE AND AFTER EACH USE TO MAKE SURE THEY ARE TIGHT.
Page 4 LIMITED WARRANTY The warrantor’s obligation shall be limited to repairing or replacing any part, which upon examination by StrikeMaster, is determined to be defective. This obligation begins on the date of purchase (as evidenced by a product receipt) and continues for a period of ONE YEAR after purchase (“warranty period”), with the exception of engines and parts subject to wear and tear.

Lazer synthetic ultra-liteLazer