General Information - Chrysler Sebring Convertible 2010 User Manual

250 STARTING AND OPERATING
NOTE: In Autostick mode, the transaxle will only shift
up or down when the driver moves the shift lever to the
right (+) or left (-).
AutoStick is deactivated when the shift lever is moved
from the AutoStick (+/-) position into the DRIVE position.

General Information

• You can start out, from a stop, in any gear except sixth.
The system will ignore attempts to upshift at too low
of a vehicle speed.
• If a ratio other than first is selected, and the vehicle is
brought to a stop, the transaxle control logic will
automatically select the first gear ratio.
• Starting out in second gear is helpful in snowy or icy
conditions.
• Avoid using speed control when Autostick is en-
gaged.
• The transaxle will automatically shift up when maximum
engine speed is reached while Autostick is engaged.
• Transaxle shifting will be more noticeable when
Autostick is engaged.
• If a low range is selected and the engine accelerates to
the rev limit, the transaxle will automatically select the
next higher ratio.
• If a downshift would cause the engine to over-speed,
that shift will not occur until it is safe for the engine.
Mostly the transaxle will stay in the manually selected
ratio, however:
− If the system detects powertrain overheating, the
transaxle will revert to the automatic shift mode and
remain in that mode until the powertrain cools off.
− If the system detects a problem, it will disable the
AutoStick mode and the transaxle will return to the
automatic mode until the problem is corrected.