Setting The Analog Clock - Chrysler Sebring Convertible 2010 User Manual

174 UNDERSTANDING YOUR INSTRUMENT PANEL
off if they were turned on by this feature. To make your
selection, press and hold the RESET button until ON or
OFF appears.
NOTE: Turning the headlights on during the daytime
causes the instrument panel lights to dim. To increase the
brightness, refer to "Lights" in Section 3 of this manual.
Key Off Power Delay
When this feature is selected, the power window switches,
radio, uconnect™ phone (if equipped), and power outlets
will remain active for up to 10 minutes after the ignition
switch is turned to the LOCK position. Opening a vehicle
door will cancel this feature. To make your selection, press
and hold the RESET button until OFF, 45 sec, 5 min, or 10
min appears.
Illumination Approach
When this feature is selected, the headlights will activate
and remain on for up to 90 seconds when the doors are
unlocked with the RKE transmitter. To make your selec-
tion, press and hold the RESET button until OFF, 30 sec,
60 sec, or 90 sec appears.
Display Units in English or Metric
The EVIC and odometer can be changed between English
and Metric units of measure. To make your selection,
press and release the RESET button until ENGLISH or
METRIC appears.

SETTING THE ANALOG CLOCK

To set the analog clock, lo-
cated at the top center of the
instrument panel, press and
hold the button in until the
setting is correct. The clock
will adjust slowly at first and
then quicker the longer the
button is held.