End Of Programme - John Lewis JLWD1404 Instruction Manual

Should it not be possible to open the door, and should
it be absolutely necessary to do so, switch the machine
off by turning the selector dial to "Off".
After approximately 3 minutes, you can open the door.
Pay attention to the level and temperature of
the water in the washing machine!
When you close the door to restart the programme
turn the dial to the previous programme repeating the
options previously selected and press "Start/Pause"
button.

13. End of programme

At the end of the programme, the machine stops
automatically and displays a flashing zero.
If the "None" option has been selected, the light of the
"Start/Pause" button flashes, a static zero appears on
the display, the "Rinse hold" pilot light and the door
locked light are on to indicate that the water must be
emptied out before opening the door.
To drain the water or to spin see the paragraphs
"Draining only" or "Draining and spin" on page 10.
The door can only be opened when the door locked
light has gone off.
Release of the lock is also indicated by the illumination
of the "End" light.
Turn the programme selector dial to Reset "Off" to
switch the machine off.
Remove the laundry from the washer dryer.
Check whether the drum is completely empty, by
rotating it with your hand. The purpose of this is to
prevent any items of laundry from remaining
accidentally in the drum, where they might get damaged
in a subsequent wash (e.g. by shrinking) or bleed colour
into another load of laundry.
We advise you to close the water supply tap and
disconnect the plug from the socket.
Leave the door ajar in order to air the machine.
13