Disassembling Procedures For C-Cl Light Exit - Olympus CH Series Repair Manual

/ '
AA870800
6-8 Reassemble left Dovetail AA870800 by using
two Screws CU K3x 10SA and two Washers SW
3SA. (See Fig. 6-8)
While pushing the dovetail uniformly in the
direction indicated by arrows, tighten the
screws.
Fig. 6-8
6-9 Reassemble Knob AA876300 by using two
Screws ACU2.6x3SA.
The knob should be apart about 2 mm.
(See 6-9)
6-10 Check the condenser holder for its vertical
motion.
Fig. 6-9
6-10-1
a)
b)
Check the dovetail for its play.
When the tip of the condenser holder is
swung in the right-left direction, play must
not be felt by hand.
If the dovetail plays, tighten the two screws
firmly while depressing the left dovetail
sufficiently in the direction indicated by
arrow. (See step 6-8 above)
7. DISASSEMBLING PROCEDURES FOR C-CL LIGHT EXIT
1L--_AA290200
7-1 Remove Ring AA871600.
NOTE:
The ring is bonded at one point with Araldite.
If it cannot be loosened with the Pin face
wrench KKAA8716, cut off Araldite by using
tweezers or the similar tool.
7-2 Disassemble the lens system:
Lens LA410800
Ring AA290100
Filter LP072100
Ring AA290200
Lens LA510900
- 37-