PowerWasher H1700 User Manual page 25

PROBLEM OR cONcERN
Unit will not stop when trig-
ger is released
Wand - Attaching
Wand - Removing
POSSIBLE cAUSE
Garden Hose is kinked or
leaking water
Wand is malfunctioning
Gun is not operating properly
SOLUTION
Make sure the Garden Hose is laid out flat and
there are no kinks in it. The hose should not be
wrapped on a storage wheel. Make sure the
faucet is open all the way and there is a full
volume of water reaching the unit.
Test both wands to ensure that one is not mal-
functioning.
Remove Wand from the Gun and squeeze trigger to
ensure that the water is coming out of the front of the
Gun at a rate equal to the Garden Hose.
To attach the Wand apply some moderate
downward pressure force on the Wand (In the di-
rection of the trigger) while simultaneously twisting
the wand a 1/4 of a turn counterclockwise. (It may
help if you set the gun vertically on a flat surface
with the wand pointing upwards). The two tabs on
the end of the Wand must slide all the way in before
the Wand will twist and lock. If this does not work
remove the o-ring from the end of the wand and
attach it without the o-ring. If the wand attaches,
you will need to replace the o-ring. Contact us at
customerservice@hdpowerwasher.com
or order a replacement directly online at www.
hdpowerwasher.com.
Release the back pressure in the Gun/Hose. Re-
move the Garden Hose from the unit and squee-
ze the trigger of the Gun. Apply some moderate
downward pressure force on the Wand (In the
direction of the trigger) while simultaneously
twisting the wand a 1/ of a turn clockwise. (It
may help if you set the gun vertically on a flat
surface with the Wand pointing upwards). For
additional assistance you can email us at
customerservice@hdpowerwasher.com.

H1700