PowerWasher H1700 User Manual page 24

H1700
PROBLEM OR cONcERN
Trigger will not move
Unit will not start
Note: Unit will only start when
trigger is depressed.
Unit stops while operating
Unit will not stop when trig-
ger is released
POSSIBLE cAUSE
Kink in the Garden Hose or Hose
is wrapped on a storage wheel
Detergent Suction Assembly (the
part which the High Pressure
Hose connects to) is defective
Gun/Hose Assembly is defec-
tive
Gun Safety lock in engaged
Unit is not turned on
loose or disconnected Plug
Defective GFCI Plug
Extension Cord length or gauge
incorrect
Gun trigger not operating pro-
perly
Defective Gun
Tripped Pressure washer
Thermal Switch
Defective ON/OFF Switch
Screen filter is clogged
SOLUTION
Unwrap the Garden Hose and lay it out flat to
ensure that there are no kinks in the Hose.
Remove the Gun and Hose assembly from the
front of the unit. Aim water stream away from
electric source. Turn the faucet on. Water should
start to come out of the front of the unit. If no wa-
ter comes out, the Detergent Suction Assembly
will have to be replaced. Contact us at
customerservice@hdpowerwasher.com
or order a replacement directly online at
www.hdpowerwasher.com.
Attach the Gun/Hose to the front of the unit
with no wand attached to the Gun. Squeeze the
trigger of the gun to ensure that water comes
out of the front of the Gun at a rate equal to the
Garden Hose. If no water comes out of the Gun
it will have to be replaced. Contact us at
customerservice@hdpowerwasher.com
or order a replacement directly online at
www.hdpowerwasher.com.
Release Safety lock as instructed in Manual.
Press ON/OFF Switch into ON position.
Reconnect Plug.
Perform GFCI reset procedure as instructed in
Section .0. If the Plug does not reset it will
need to be replaced. Contact us at
customerservice@hdpowerwasher.com
or order a replacement directly online at
www.hdpowerwasher.com.
Use proper Extension Cord as instructed in section
.0.
Contact us at
customerservice@hdpowerwasher.com
or order a replacement directly online at
www.hdpowerwasher.com.
Remove the Gun and Hose assembly from the front
of the unit. Aim water stream away from electric
source and switch the unit into the ON position.
If the unit starts and water comes out of the front,
the Gun may need to be replaced. Contact us at
customerservice@hdpowerwasher.com
or order a replacement directly online at
www.hdpowerwasher.com.
Allow to cool and restart unit.
Contact us at
customerservice@hdpowerwasher.com
or order a replacement directly online at
www.hdpowerwasher.com.
Clean the Screen filter as instructed in the sec-
tion ..