Barco F22 Quick Start Manual

1
ge tt i n g s t a r te d
This Quick Start Guide has been designed to aid in quickly getting started with using your new projector. If you require further help, or have further questions on the
detail in how to operate this unit, please refer to our web site at userguides.projectiondesign.com, in order to download full product documentation. You can also
access FAQs, and download detailed white papers in order to get to know the more specific product features and benefits.
Packaging contents:
projector unit
* The lens type on your projector may deviate from the pictures
2
ge t t o k n ow t h e c o n ne ct or p an el
The projector features connectors for a wide variety of sources, both digital and analogue, including HDMI 1.3, DVI-D and DVI-A, VGA, and component, S- and
composite video, in additions to network, USB and RS232 control options, as well as a remote 12V trigger and wired remote control input:
3
c o n n e c t so urce s , co nn ect p owe r, p ow er on
Make sure the projector is switched off, and not connected to power when connecting sources. Connect video and computer sources, then insert the power cable.
Power up sources, including computers and video playback devices. Power up the projector by pressing the power key (
indicate that it is in operation. CAUTION! Connecting sources to a powered projector may result in product failure. It is recommended that the power cable connector
(projector-end) or the mains power socket are accessible whilst the product is in use to enable mains power to be disconnected or switched off when connecting
source devices. This should be considered during product installation.
remote control power cable
product documentation
). A steady, bright indicator light will
P le as e v is it ou r w e b si t e t o d ow n l oad f u l l u s er m a nua l o r f i nd re l a te d i nf or m at i o n
4
a dj ust pr oj ec to r se t ti ngs
Adjust zoom to set correct image size, focus for image sharpness, and other desired settings, such as lens shift, tilt, and keystone. Adjust image level with the rear
feet, and tilt with the front foot.
C
A B
A: Focus B: Zoom C: Adjustable rear feet
5
a dj us t i ma ge a nd sys te m se t ti ngs
Change and adjust settings such as brightness and contrast, ceiling mount and rear proejction settings, as well as colour calibration and other system settings by
using the remote control or through the menu system.
6
powe r of f a nd al l ow to c oo l down
To power off, press the power ( ) key once, and confirm by pressing again. Allow to cool down until all fans have stopped (a minimum of 30 seconds), and a steady
amber indicator light indicates the projector has been safely turned off. Disconnect any cables, sources and power cables before packing the projector.
The cabinet colour may differ from the one shown in the pictures
When referring to the term F22 in this document, it means that the content is applicable
for the following Barco products:
• F22 1080
• F22 WUXGA
• F22 SXGA+
F22
Quick Start Guide
D
E
D: Lens shift E: Adjustable front foot
>30 s
www.barco.com