Dependent Rpms For Remote Enablement - Dell Server Installation Manual

Dependent RPMs For Remote Enablement

If you choose to install the Remote Enablement feature, you have to install certain dependent RPMs and configure these
RPMs before installing the feature. Install the following RPMs:
• libcmpiCppImpl0
• libwsman1
• openwsman-server
• sblim-sfcb
• sblim-sfcc
The dependent RPMs are available on the
\RPMS\supportRPMS\opensource-components\<OS>\<arch>.
NOTE: On supported SLES 11 and above and Red Hat Enterprise Linux 6 and preceding operating systems, it is
recommended that you install the RPMs from the operating system media, if available.
Installing Dependent RPMs
To install the dependent RPMs not available on the operating system media:
1. Make sure that Pegasus RPMs are uninstalled.
2. Check if the openwsmand and sfcbd binaries are already installed using make-install. Check by running the
commands: openwsman or sfcbd or you can check the existence of the binaries in the /usr/local/sbin directory.
3. If the binaries are installed, uninstall these binaries.
4. Check for the required dependencies for the openwsman and sfcbd RPMs listed in the following table.
Table 5. Required Dependencies
Packages
Openwsman
SBLIM SFCC
SBLIM SFCB
5. Install the dependent RPMs. You can install the RPMs:
– with a single command rpm -ivh rpm1 rpm2 rpm3 rpm4 ... rpmN
or
– individually
26
Systems Management Tools and Documentation DVD at srvadmin\linux
Red Hat Enterprise Server
OpenSSL
LibXML
Pkgconfig
CURL
Chkconfig
Initscript
SBLIM-SFCC
CURL
zlib
CURL
PAM
OpenSSL
Chkconfig
Initscript
SUSE Linux Enterprise Server
LibOpenSSL
LibXML
Pkg-config
libCURL
aaa_base
aaa_base
SBLIM-SFCC
LibCURL
zlib
LibCURL
PAM
LibOpenSSL
aaa_base
aaa_base