Table of Contents
Advertisement
OR
$ xe-install-supplemental-pack <openmanange-supplemental-pack-filename>.iso
NOTE: If a previous version of Server Administrator is already installed on the system, then the command to
upgrade it to version 7.0 is ./install.sh.
After the installation or upgrade, execute the following post-installation configuration script of Remote Enablement
feature
$ cd
/opt/dell/srvadmin/etc
$ ./autoconf_cim_component.sh
3.
When the installation is complete, unmount the ISO file or CD:
$ cd ..
$ umount /mnt
CAUTION: Removal of the Supplemental Pack or any RPMs is not supported by your service provider or Citrix
and it is not recommended. Manual removal of any RPM leaves the system in an inconsistent state which
could make any potential issue debugging effort difficult or impossible. A future Supplemental Pack release
supports removal of the Supplemental Pack.
XenServer Upgrade
If the XenServer image is upgraded to a newer XenServer update or release, the Supplemental Pack must be reinstalled
since the new XenServer image is placed on a different partition from the original. In this case, follow the same
installation instructions as before. However, any systems management configuration settings saved on the server is lost.
NOTE: If you are connecting to a XenServer 6.1 managed node using server administrator web server, use port
5986 in the format Hostname:Port Number, or IP address:Port Number.
Post Installation Tasks
After the installation or upgrade of Server Administrator:
1.
Execute the post installation configuration scripts of Remote Enablement feature:
$ cd /opt/dell/srvadmin/etc
$ ./autoconf_cim_component.sh -p 5986
$ service iptables save
or
$ /etc/init.d/iptables save
2.
Restart openwsman and sfcb services:
$
/etc/init.d/openwsmand restart
$
/etc/init.d/sfcb restart
NOTE: In case the openwsman services do not start properly, you may need to reboot the server.
3.
Open the port 5986:
$
iptables -I RH-Firewall-1-INPUT -p tcp --destination-port 5986 -j ACCEPT
4.
Start the Server Administrator services:
$ sh srvadmin-services start
68
-p
5986
Advertisement
Table of Contents
