Rear Panel Connectors - DIS CDS 4000 User Manual & Installation Manual

CDS 4000
4.
Enter
This button is used to enter the menus and select
a chosen value.
The markers < > around exit show the function
which can now be selected with the ENTER
button. If it is pushed again now, we will get
back to the master (default) display shown
above.

Rear panel connectors

1.
Mains Connector
Connection for mains power. The unit can
accept the following voltages:
110V/130V/150V/220V/240V/260V depending
on the setting of the internal switch.
Before connecting the CU4005/CU4010 Central
Unit to the mains, please check that the voltage
shown on the label close to mains socket is in
conformity with the voltage with which it is to
be used.
2.
Microphone Chain
Connector for the first DM/CM4000 Unit
connected in the chain. A maximum of 50
microphone units can be connected at a time.
3.
Expansion of more CU4005/CU4010s
More central units are connected to these
connectors for systems with more than 50/100
microphone units. The MC4000 Microphone
Manual no. 4479, Printed in Denmark, 02/03
5.
< and >
These buttons are used to step the markers < >
left and right respectively for each push.
6.
LCD Display
Indicates the setting of the system.
controller is also connected here. A maximum of
ten CU4005/CU4010 units and two MC4000s
can be interconnected.
The central unit with none or only the MC4000
connected to the PREVIOUS connector
becomes the master unit.
4.
Microphone Output
The output delivers the signal from the
microphones independently of the Microphone
Volume setting on the front panel. Also, the
output is totally independent of the input signal.
The output signal is typically used for tape
recording or an external PA-system and is
nominal 0 dBm line-signal and –40dBm
microphone level respectively.
OPERATION
15